Homey Community

Adding device Neo Coolcam doorsensor ''ontwakingsperiode wordt opgehaald''


#1

Hi guys,

I am trying to connect another doorsensor, but everytime I get stuck at the last part. “ontwakingsperiode wordt opgehaald” (awakening periode being fetched??) and then nothing happens. Eventually the process stops telling me no device was found??

I’ve already done a full reset on the doorsensor and a restart of homey.

Anyone with a solution??


#2

have you tried removing it first from the zwave network? Maybe that wil help

greetz Frans


#3

Yes, funny enough it is added to the zwave network although it gave an error. I have already removed it again but this still resulted in the same ‘‘errors’’.

Update: The third time it got stock at: Association groups instellen…


#4

Is there an issue with adding nodes?

1.5.13 experimental

  • [433 Mhz] Improved signal reception and transmission

  • [868 Mhz] Improved signal reception and transmission

  • [Z-Wave] Fixed a bug where Z-Wave packets could be delivered after a delay

  • [Z-Wave] Fixed a bug that could prevent Z-Wave S2/FLiRS nodes from pairing

  • [Z-Wave] Added a remove node button in the developer tools

  • [Z-Wave] Fixed a bug that could prevent failed devices from being deleted

  • [ZigBee] Better handling of Xiaomi data

  • [IR] Fixed a bug where homey would freeze when speaking while sending IR

  • [Signals] Improved signal parsing for unit-based signals

  • [Signals] Improved signal parsing for signals without SOF

  • [Other] Fixed an issue that could cause slow boots

  • [Other] Fixed an issue that could cause a red ring during boot

  • [Other] Fix a bug where some Homeys could experience problems when connecting to wifi networks when a 5GHz network with the same name exists

  • [Core] Update Node.js to 8.12.0

  • [Other] Various bugfixes and minor improvements


#5

Probbely you did, but to be sure…. you adding within a few cm from homey?


#6

Yes, the other one was added without any problems


#7

Maybe got a faulty one, or the battery isnt full (did you check it)


#8

Yes. I swapped batteries with an other one. No Joy!


#9

Dunno if this is the problem but swapping it with another one is not the same as checking. Measure is the only good option.


#10

Done! Took a new battery out of the box, still nothing???


#11

So stil not measure it :joy::joy::joy::joy:

But i start to think, you got a faulty sensor.