This app works like a charm. Any chance to update for the new Zigbee products too?
I bought the Nodon Pro multifunction zigbee unit but is not supported by Homey yet
Iāve started to talk with NodOn themselves for any future plans of the app, what it will conclude in, iām not sure yet, but it can only get better from here on out.
So support for their zigbee devices (and Homey Bridge support) will come, in due time.
@Caseda Do you implement Bridge support in Nodon or Nodon themselves? Could you specify āin due timeā? Iām trying bridge for 30 days, but have a lot of non-compliancy (yet) to overcome. For now only half of my Zwave system (Fibaro, Qubino, Forest, Aeotec) is supported, but especially Nodon and Neo Coolcam are not.
NodOn has taken up the app on their own for the zigbee devices and bridge support, I could do it for them, but just lack the time currently for it.
There is no due time, NodOn is/was currently in the process of seeing how Homeyās implementation works, and thatās the end of what I know of how far they are.
1 Like
I make use of a NodOn Soft remote to control a device that sometimes has connectivity issues. With advanced flows I can now set flow cards on the success/failure of an earlier card. I now use this to send an error message to my phone. I would however like it to flash up the NodOn Soft Remote led blue or red. Such a card does not exist (yet). Is this something that is technically feasible?
There is some LED management described in the manual, but it looks like it only reacts to the ācommand receivedā notificatie and canāt be controlled directly.
The remote is a regular battery Z-Wave device, which means it wonāt receive any signals until it wakes up as it will be asleep to save on battery (in the case of Nod-On, by default, it will never wake up).
The LED management is indeed only because a z-wave devices always waits for a āAcknowledgeā signal back (signal that the signal previously send was received) which it can respond on (thatās the benefit of Z-Wave and the reason it is called a 2-way protocol)
Hi. Is it possible to support the NodOn Zigbee 3.0 Rollershutter and Relays?
thank you
Don
Youāll have to ask nodon themselves if they can add it into the zigbee app, this one is about the community Z-wave one.
That would be great. I had it working well on my smartthings, but on Homey it is not working (yet 
). Thanx in advance.
