Homey Community Forum

Danalock V3 pairing issues

Hi Community,

i have issues adding my new Danalock v3. At the end of the pairing process I either get the message that no zWave device was found or ”status.already_added“. However, the lock never shows up among my devices… anyone had the same issues?

Try to exclude the device first.
Settings -> Z-Wave -> remove any Z-Wave Device
Star the Inclusion/Exclusion on the device
Then try the inclusion again.
Do it very close to homey cm!!

You could also check the developer page to look for the device.

Often you have to have the Z-wave device really close to your Homey when pairing.

1 Like

Thanks! That did the trick…

What did the trick?

Bringing the lock really close to Homey…

Check here.

Tried all the above, multiple times, other suggestions?