Homey Community Forum

ECODIM App

Hi! My first attempt at Homey, EcoDim, Homey Community Forum, etcetera. I cannot add my ECO-DIM ECO-DIM.07 PRO Z-Wave at all to EcoDim App v1.1.1 on my Homey Pro (Early 2019) v4.2.0.


Hi @Thomas_Hedenstrom welcome!

The Eco-Dim.07 Pro dimmer is supported by the current EcoDim app, under the name Eco-Dim.07.

Hi @TedTolboom, and thank you! I am getting through the first of two steps but then it stops at as per attached image.

For step 1: Press the RESET button twice, wait for the first green check-mark.
For step 2: Wait until the connected light stops changing dim level (~5 seconds), then press the RESET button twice. That should give the second green check-mark

1 Like

I have a ECO Dim dimmer with Zigbee and works good. But only once a month the status of the light is not correct. In Homey it is on but the light is of. Is this a known problem?
Homey version 4.2. Not V5.

Thank you very much! I’m almost there but it seems I was rushing things and now have a device added which is not connected to my dimmer but cannot be removed. I cannot force remove it via settings either.

Hi Mike! Are you able to use the Zigbee protocol, for Eco-Dim.07 Pro? I can only add the Z-wave and also see several instructions for red lights which never blink.

I have bought the Zigbee version so i have to use the Zigbee dimmer.
I use 1.1.1
On the box there is no Pro. It is the 07 version.
On the website is this.
Artikelcode:
ECO-DIM.07 PRO Zigbee
EAN: 8719322371263
I have the same EAN code.

Thank you @TedTolboom, I got it working but had to add the dimmer as a 2019 model and then it comes up as a 2020 model. The red and blue blinking on my dimmer does not match the App for some reason. Many thanks for your assistance!

Thanks @Mike1233. I get it and that makes sense. One app for both. I’ve baked the noodle long enough now.

I’m not sure if the flashing of the lights was the correct color for me as per the description. But that was already a few months ago.
Good to hear it works.

1 Like

@TedTolboom

I got an unknown device message. See attached picture for hardware info. Any idea how to solve this? Other 6 dimmers are working fine

Thanks for the explanation of step 2, I had to check the forum earlier :blush: