Pre 2.0 I used a flow to switch the lights when entering home and it was dark. Using hue and a Fibaro motion sensor.
It looked like;
When the motion alarm is triggerd
AND
LUX = less then 4
Hue GU10 2 = off (extra to be sure it won’t happen in a choosen low light scene)
THEN
Turn on the lights (hue and some wall sockets)
But in 2.0 I come to this;
WHEN
The luminance changed
AND
Luminance is less than 5
GU10 2 is turned off
THEN
Turn on the lights
But in someway the flow isn’t triggert when arriving at dark and triggers a few times in the night when there’s no movement.
So what could it be. I have some difficulties in re-creating flows in the new interface.
Thanks,
Martijn
bvdbos
January 31, 2019, 8:55pm
3
Why not the same flow as in 1.5.x? Your second flow will always run, regardless if your home or not… Even at night…
True but when I start with;
When the motion alarm is on, there is in the AND selection just the motion alarm is on and the tamper alarm is on available. I don’t see any options for luminance then.
I lost all my flows migrating 2.0 @bvdbos
bvdbos
January 31, 2019, 9:13pm
6
You can still use the sensor-values, there’s just no local tags for the trigger “motion alarm”:
@bvdbos I see now, it’s by adding the logic labels then.
New flow;
WHEN
the motion alarm turned on
AND
Luminance is less than 2
GU10 2 is off
THEN
Turn on everything in a most fancy way