Currently i am struggling with my NEO Coolcam PIR V2’s. I have PIR’s installed, 1 on the 2nd floor and 1 in the kitchen (ground level). Always seamlessly performing until 2 weeks ago.
During a birthday party i assume the PIR in the kitchen somehow freaked out (because of people continuously moving around in the kitchen) and was left with a dead battery at the end of the day. Yesterday i’ve received my new batteries but the Kitchen PIR is acting strange. It keeps seeing motion continuously while nobody is in the kitchen.
I already removed the PIR Kitchen, which initially works but somehow (i guess) a new routing is created which screws up the performance of my PIR Kitchen which keeps seeing motion the whole time. I noticed a difference in the routing sequence. 1-25 (Homey and PIR Kitchen) works great. After a while the routing changes into 1-10-25 (Homey, Fibaro Roller Shutter in the kitchen and PIR Kitchen) and my PIR Kitchen doesn’t stop seeing motion.
With a heal on 25 the routing changes back to 1-25 but after a while changes again to 1-10-25
- How can i change the sequence? 10 (Fibaro) was initially the last item i have bought and added to the network long before the birthday. Do i need to reset my Z-wave network and add every item in the same sequence as in the beginning? Unfortunately i do not know how the initial Z-Wave routing looked like since i ran into the developer overview during this issue
- How bad is the difference in numbers (1,7,10, 19 and 25)?
This is driving me nuts. What i can tell from other topics this emotion is a common side-effect