Homey Community Forum

[Virtual Devices] Virtual Thermostat AND-check does not work

Dear Community,

I have been using Virtual Devices, the app, for a while to create numerous virtual devices for both my own Homey and customers. Now I have run into a problem when using a virtual Thermostat. A VD-Thermostat has 4 different modes: Auto, Heat, Cool and Off. These work, but when I use an AND-card to check for if a modus is eg. Auto, I get the error shown in the attached image. I have tested this and its the same for 5 different VD-Thermostats. Anyone got any suggestions for fix?

try to use the homey logic instead of the vd card.