Fibaro fgs 224 inclusion problems

[Martijn_C]

Your help is very much appreciated!

[Martijn_C]

@Bavoc Athom says the new beta app should fix these issues. Did you try that one?

Fibaro

[Bavoc]

Good point, I didn’t check the test version yet this time.
So I did and the issues I encountered seem to be solved

[Rob_Veenis]

After the last Homey update I included the unit again (after excluding) and now it works properly

[EricJ]

Now my FGS-224 works correctly in ON / OFF switch mode on the 2 relays but the “momentary switch” function does not work, the switch remains on, there is no time delay.

[Maurice_Deters]

Latest Homey update, experimental Fibaro update and re-including the device made it fully functional!

[Emmanuel_Cabestan]

Works well for me with last homey update and official fibaro app.
But I had to do pairing again.

The pairing ask now to enter pin code (written on the module)

[Bavoc]

Hi Eric,

I was also confused about the momentary switch setting, I think this has to do with switch input type, not relay operation.

I think you need to use raw parameters to do what you want (close relay for one second and then reopen)

Ex: 150,1,2 such as @Wilco_Slaats explained in a post above from April 26

[EricJ]

Hello Bavoc,

Thank you for your answer, I do not control the raw parameters so to remedy this problem I added a virtual button and created a rule and it works correctly.

THX